RAD Data comm Modular Access Device with Integrated Router Manuale Utente

Chapter 4  Configuration 

FCD-IPM Installation and Operation Manual 

4-10 

Quick Setup Menu

 

 

Default Gateway 

Setting 

 

Select this parameter to set the Default Gateway configuration 

(see 

). The default gateway is the address to which 

frames are sent, if no other address is defined in the routing 

table. 

The default gateway can be an IP address or a WAN interface. 
If you choose to use an IP address, enter the address of the 

router, which will deliver the frames. Specifying an IP address 

for the default gateway is done with shared media, such as LAN 
interface. If you choose to use a WAN interface, the connection 

to the router is point-to-point. Choose by interface and enter 

interface/DLCI number (for Frame Relay). 
Warning: It is very important to obtain the correct parameters 

try to guess these parameters. 

E1/T1 Settings 

 

Prompts to perform advanced configuration on the main link 
settings – E1 or T1, depending on your unit. By entering YES 

you are sent into the Advanced Configuration menu. For more 

information, refer to 

. 

 

LAN IP address 192.168.1.1

Mask                  255.255.255.248

IP address 
Mask 
Default Gateway                

192.168.1.2
255.255.255.248 
192.168.1.1

192.168.1.3
255.255.255.248
192.168.1.1

192.168.1.4
255.255.255.248
192.168.1.1

192.168.1.6

255.255.255.248
192.168.1.1

192.168.1.5

 255.255.255.248
192.168.1.1

FCD-IPM