Lopi 864 ST Manuale Utente

Operation

4071130

100-01196_000

Before You Begin

•

Read  this  entire  manual  before  you  use  your  new  fireplace  (especially  the  section  "Safety
Precautions"  on  pages  4  &  5).    Failure  to  follow  the  instructions  may  result  in  property  damage,
bodily  injury,  or  even  death.

Location of Controls (front side only)

AAAAAAAA

AAAAAAAAA

Lift the control cover up and swing it

forward to access the controls.

Pilot Igniter

ON/OFF Switch

Flame Adjust Knob

Gas Control Knob

An instruction card for operating

the fireplace is attached to the

inside of the fireplace here.

Replace it for easy reference.

The Pilot Flame can be

found under the center log (it

is best viewed at a low level).

Comfort Control

Gas Control Valve

Optional Blower Control

Optional Accent Light

Pilot Igniter

The pilot igniter is used only to start the pilot.  When pressed, it sends an
electrical  charge  to  the  pilot  assembly.    This  creates  a  blue  spark
directly  next  to  the  pilot,  igniting  the  pilot  flame.

On/Off Switch

This control is used to turn the fireplace burners on and off.

Gas Control Knob

This  knob  is  used  to  control  gas  to  the  fireplace  and  for  starting  the  pilot.
There  are  three  positions,  ON,  OFF,  &  PILOT.    The  pointer  to  the  left  of
the  knob  indicates  the  position  this  knob  is  in.

Flame Adjust Knob

This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.

Comfort Control

This lever turns the rear burner on and off.
NOTE: THIS IS NOT A SHUTOFF VALVE.

Optional Blower Control

This knob controls the speed of the optional internal convection blower
that pushes heated air into the room.

Optional Accent Light

This knob controls the optional accent lights located behind the logs.