Lopi 864 ST Manuale Utente
8
Operation
© Travis Industries
4071130
100-01196_000
Starting the Fireplace for the First Time
•
Burn the heater at a high setting with the blower off for an extended period (up to 48 hours).
This will cure the painted surfaces. Fumes from the paint curing and oil burning off the steel
will occur. This is normal. We recommend opening a window to vent the room.
This will cure the painted surfaces. Fumes from the paint curing and oil burning off the steel
will occur. This is normal. We recommend opening a window to vent the room.
•
Condensation may appear on the glass each time you start the fireplace - this is normal.
•
Blue Flames will occur on the fireplace when it first comes on. After fifteen minutes the flames
will turn a more realistic yellow and orange color.
will turn a more realistic yellow and orange color.
•
Certain installations use a remote "wall switch" to turn the fireplace on and off. If this is the
case, leave the ON/OFF switch "ON".
case, leave the ON/OFF switch "ON".
Turning the Fireplace On and Off
After the pilot has been started...
OFF
ROOM TEMP
°F
°F
SET TEMPTIMER
MIN
Time
Set
Time
Cancel
A
u
t
o
OFF
ON
A switch is provided behind
the control cover (below
the firebox).
An optional remote may be
used (see the instructions
included with the remote).
An optional wall thermostat
may be used to control the
temperature.
A wall switch may be
used to turn the
fireplace on and off.
NOTE FOR REMOTES, THERMOSTATS, OR WALL SWITCHES:
The on/off switch on the fireplace may be required to be left in the ON or OFF position for the fireplace
to operate. Consult your installer or dealer for details.
The on/off switch on the fireplace may be required to be left in the ON or OFF position for the fireplace
to operate. Consult your installer or dealer for details.
•
Do not place any combustible items on top of or directly in front of the fireplace, even
temporarily. The optional thermostat may start the fireplace causing a combustible item to
ignite.
temporarily. The optional thermostat may start the fireplace causing a combustible item to
ignite.
•
If the fireplace turns on and off frequently while using the thermostat, you may want to adjust
the flame height down until it produces just enough heat needed.
the flame height down until it produces just enough heat needed.
Adjusting the Flame Height
•
Your fireplace has an adjustable flame to tailor the look and heat output to your specific needs.
It is adjusted by turning the middle dial on the gas control valve.
It is adjusted by turning the middle dial on the gas control valve.
Flame Height
Adjustment Knob
Adjustment Knob
Index Mark
Turn counter-clockwise to adjust the flame higher, clockwise to lower.