Lopi 864 ST Manuale Utente

© Travis Industries

100-01196_000

The  blower  helps  transfer  heat  from  the  heater  into  the  room.    It  will  not  turn  on  until  the  heater  is
up  to  temperature  (approximately  10  minutes  after  starting).    See  the  illustration  below  for
instructions  on  adjusting  the  blower  speed.

Turn the dial all the 
way counter-clockwise 
until it clicks off.

The high position is all the 
way counter-clockwise, 
without clicking off.

Turn the dial all the 
way clockwise.

As the gas control valve is turned 
on and off you will hear a dull 

clicking sound.  This is the valve 

opening up and shutting down.

Blower Snap Disk 
This part can produce a 

clicking sound  as it turns 

the blower on and off.

The appliance may creak with change of 

temperature -- THIS IS NORMAL.

Pilot Flame
The pilot flame, which remains on, 

makes a very slight "whisper" sound.

Blowers
This heater has optional blowers to push 

heated air into the room.  You will hear the 

sound of air movement that increases as 

the speed is increased.

Extinction Pops 

It is not unusual, especially on Propane 

(LP) appliances, to experience a "pop" 
when the burner is shut off.

This  appliance  has  several  areas  that  reach  high  temperatures.    Dust  or  other  particles  on  these
areas  may  burn  and  create  an  odor.    This  is  normal  during  start-up.    You  may  notice  the  smell  is
more  acute  if  the  appliance  was  left  idle  for  a  long  period.