Hoover cleaner Manuale Utente

Lift out filter (F) and hand wash it in cold
water with mild detergent.

Let filter air dry and reposition it on 
the front of the cleaner. Reposition retain-
er and filter bag door.

Should you want to replace this filter, ask
for HOOVER 

Pull old bulb straight out of socket.
Push new bulb straight into socket until
locked in place.

Reposition hood and push firmly to snap
it into place on the sides and at the
front.

It is not necessary to turn the

cleaner over and use a screwdriver to
remove the hood once you are familiar
with the 2 places on the hood (indicated
by arrows in Fig. 3-6) that unlatch it.
Simply pull the sides of the hood out-
ward at those areas and lift off the hood. 

The belt on your HOOVER cleaner 
causes the agitator to rotate and is
important for the effective operation of
the cleaner.  The belt is located under
the bottom plate of the cleaner and
should be checked from time to time 
to be sure it is in good condition.

To check belt, remove bottom plate as
shown in “How to replace.”  Replace
belt if it is stretched, cut or broken.

To assure effective operation, use only
genuine HOOVER belts with your 
cleaner.  When purchasing a new belt,
ask for Hoover 

Insert brush roll through belt and place
belt in belt guide (I) on brush roll.

Grasp brush roll firmly and fit it into posi-
tion by first sliding belt side into the rec-
tangular slot (J) on side of cleaner.
Pull other side of brush roll (K) into place.
Turn brush roll making sure belt is not
pinched between brush roll and cleaner
base. 

Place handle in low position and turn
cleaner over.

Remove the 2 screws as shown with a
Phillips screw driver.  

Lift  bottom plate at (G) and rotate it off
the cleaner.

Remove agitator brush roll and 
used belt. 

Discard used belt.

With lettering on outside of belt, pinch
belt into a loop and twist slightly to
slide new belt over motor pulley (H).

This cleaner uses a 12 volt, wedge base
type 912 bulb, Hoover 

Place handle in low position and turn
cleaner over.

Hood snaps off by inserting the end of
a flat screwdriver into one of the areas
(labeled with an arrow) on either side  of
the cleaner as shown. Push screwdriver
outward to release hood.  Repeat on the
other side and remove hood.