Patton electronic SmartNode 4110 Series Manuale Utente
FXO interface configuration task list
419
SmartWare Software Configuration Guide
36 • FXO interface configuration
Mode: Interface FXO
Now we can apply the PSTN profile for the FXO interface named name as follows.
Configuring when the digits are dialed (optional)
When the FXO port goes off-hook to make an outgoing call, the FXS switch normally sends a dial-tone to
indicate it is ready to received dialed digits. Alternatively, you can specify the FXO interface to wait a specific
period of time after going off-hook before dialing the first digit.
indicate it is ready to received dialed digits. Alternatively, you can specify the FXO interface to wait a specific
period of time after going off-hook before dialing the first digit.
Note
All countries do not have the same dial-tone. For information on configur-
ing the dial-tone for your country, refer to chapter 42,
ing the dial-tone for your country, refer to chapter 42,
The default setting is to wait for the dial-tone. If you choose to wait a specific time after going off-hook, the
variable is timeout and specify the number of seconds to wait. Zero (0) seconds means that the interface dials
immediately.
variable is timeout and specify the number of seconds to wait. Zero (0) seconds means that the interface dials
immediately.
Step
Prompt, command & response
Purpose
1
node>
Basic prompt in Operator Exec mode
2
node>enable
Enters Administration execution mode
node#
Response: The prompt in administration execu-
tion mode is the #
tion mode is the #
3
node#configure
Enters the Configure configuration mode
node(cfg)#
Response: The prompt in the Configure configu-
ration mode is (cfg)#
ration mode is (cfg)#
4
node(cfg)#context cs
Enters the Context CS configure mode
node(ctx-cs)[switch]#
Response: The prompt in the Context CS configu-
ration mode is (ctx-cs)[switch]#
ration mode is (ctx-cs)[switch]#
5
node(ctx-cs)[switch]#interface fxo if-name Enter the Interface FXO configuration mode
node(if-fxo)[if-name]#
node(if-fxo)[if-name]#
Response: The prompt in the Interface FXO con-
figuration mode is (if-fxo)[if-name]#
figuration mode is (if-fxo)[if-name]#
Step
Prompt, command & response
Purpose
6
node(if-fxo)[if-name]#[no] use profile pstn profile-name The “profile pstn” command is
applied to the FXO interface
named if-name
named if-name
node(if-fxo)[if-name]#
Response: You are now in the
FXO interface configuration
mode. In this mode, you may con-
figure the parameters for the FXO
interface name.
FXO interface configuration
mode. In this mode, you may con-
figure the parameters for the FXO
interface name.