Patton electronic SmartNode 4110 Series ユーザーズマニュアル

FXO interface configuration task list

SmartWare Software Configuration Guide 

Mode: Interface FXO

Now we can apply the PSTN profile for the FXO interface named name as follows.

When the FXO port goes off-hook to make an outgoing call, the FXS switch normally sends a dial-tone to 
indicate it is ready to received dialed digits. Alternatively, you can specify the FXO interface to wait a specific 
period of time after going off-hook before dialing the first digit. 

All countries do not have the same dial-tone. For information on configur-
ing the dial-tone for your country, refer to chapter 42,

The default setting is to wait for the dial-tone. If you choose to wait a specific time after going off-hook, the 
variable is timeout and specify the number of seconds to wait. Zero (0) seconds means that the interface dials 
immediately.

Basic prompt in Operator Exec mode

Enters Administration execution mode

Response: The prompt in administration execu-
tion mode is the #

Enters the Configure configuration mode

Response: The prompt in the Configure configu-
ration mode is (cfg)#

Enters the Context CS configure mode

Response: The prompt in the Context CS configu-
ration mode is (ctx-cs)[switch]#

node(ctx-cs)[switch]#interface fxo if-name Enter the Interface FXO configuration mode
node(if-fxo)[if-name]#

Response: The prompt in the Interface FXO con-
figuration mode is (if-fxo)[if-name]#

node(if-fxo)[if-name]#[no] use profile pstn profile-name The “profile pstn” command is 

applied to the FXO interface 
named if-name

Response: You are now in the 
FXO interface configuration 
mode. In this mode, you may con-
figure the parameters for the FXO 
interface name.