Multi-Tech Systems iCell GPRS (MTSMC-G2-IP Manuale Utente
Part 6 – AT Commands for GPS-Enabled Devices
Chapter 16 – AT Commands for GPS-Enabled Devices
Universal IP AT Commands Reference Guide (Document S000457K)
92
Chapter 16 – AT Commands for GPS-
Enable Products
#GPSSERV – Set GPS Host Server Address
Description:
This command sets the server IP address or name to which the GPS data will be sent.
Syntax:
AT#GPSSERV="<value>"
AT#GPSSERV? or AT#VGPS or AT#VALL
Values:
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or
Alphanumeric ASCII text string up to 120 characters if DNS is available. No default.
Responses:
OK
Otherwise ERROR
#GPSPORT – Set GPS Host Port
Description:
This command sets the GPS host port (TCP, UDP).
Syntax:
AT#GPSPORT=<port number>
AT#GPSPORT? or AT#VGPS or AT#VALL
Values:
1 to 65535
Default:
1
Responses:
OK
Otherwise ERROR
#GPSPROTO – Set GPS Host Protocol
Description:
This command sets the server protocol that the GPS will use (TCP, UDP).
Syntax:
AT#GPSPROTO=<value>
AT#GPSPROTO? or AT#VGPS or AT#VALL
Values:
0
UDP
1
TCP
Default:
0
Responses:
OK
Otherwise ERROR
#GPSPREFIX – Set GPS Message Prefix
Description:
This command is used to set a unique identification for each device or vehicle.
Syntax:
AT#GPSPREFIX="<value>"
AT#GPSPREFIX? or AT#VGPS or AT#VALL
Values:
Up to 4 characters in an alphanumeric string
Note:
The prefix is appended to the NMEA message before transit
Default:
" "
Responses:
OK
Otherwise ERROR