Philips 00 Manuale Utente

English

3

Connection and Installation

3.1 Connections

3.1.1

Connect the receiver to your TV and VCR

Incorporate the receiver in your existing installation as shown below / decoder receiver.

1

Plug your aerial lead plug into the "AERIAL IN" socket of your digital receiver.

2

Connect the "RF OUT" socket of your digital receiver to the "Aerial input" socket of your VCR by
means of the RF coaxial lead supplied with your digital receiver.

3

Connect the "RF OUT" socket of your VCR to the "Aerial input" socket of your TV set by means
of a RF coaxial lead.

4

Connect the "TV" SCART socket of your digital receiver to the RGB capable SCART socket of
your TV set by means of the SCART lead supplied with your digital receiver.

5

Connect the "VCR" SCART socket of your digital receiver to the "EXT1" SCART socket of your
VCR (so called OUT) by means of a SCART lead.

6

Plug all your equipment, excluding your digital receiver, into the mains.

7

Go to chapter 3.2 to proceed with the channel scan of your digital receiver.

Notes:
1- This connection also applies if your VCR has one SCART socket.
2- With this connection set up you can:

- Watch digital TV while you record analogue TV.
- Watch analogue TV while you record digital TV.
- Record the digital TV channel you are watching.
- Watch Play Back from your VCR.

12 C O N N E C T I O N A N D I N S TA L L AT I O N

6610_A5_GB.qxd  01/09/2004  12:58  Page 12