Tunturi E40 ユーザーズマニュアル

18-19 <33 33-38 39-44 45-51 52-57 58-63 >63
20-24 <32 32-37 38-43 44-50 51-56 57-62 >62
25-29 <31 31-35 36-42 43-48 49-53 54-59 >59
30-34 <29 29-34 35-40 41-45 46-51 52-56 >56
35-39 <28 28-32 33-38 39-43 44-48 49-54 >54
40-44 <26 26-31 32-35 36-41 42-46 47-51 >51
45-49 <25 25-29 30-34 35-39 40-43 44-48 >48
50-54 <24 24-27 28-32 33-36 37-41 42-46 >46
55-59 <22 22-26 27-30 31-34 35-39 40-43 >43
60-65 <21 21-24 25-28 29-32 33-36 37-40 >40

18-19 <28 28-32 33-37 38-42 43-47 48-52 >52
20-24 <27 27-31 32-36 37-41 42-46 47-51 >51
25-29 <26 26-30 31-35 36-40 41-44 45-49 >49
30-34 <25 25-29 30-33 34-37 38-42 43-46 >46
35-39 <24 24-27 28-31 32-35 36-40 41-44 >44
40-44 <22 22-25 26-29 30-33 34-37 38-41 >41
45-49 <21 21-23 24-27 28-31 32-35 36-38 >38
50-54 <19 19-22 23-25 26-29 30-32 33-36 >36
55-59 <18 18-20 21-23 24-27 28-30 31-33 >33
60-65 <16 16-18 19-21 22-24 25-27 28-30 >30

The equipment requires very little maintenance. Check, 

however, from time-to-time that all screws and nuts are 

tight. 

After exercising, clean the equipment with a soft, 

absorbent cloth. Do not use solvents.

Never remove the equipment’s protective casing. 

The electromagnetic brake forms a magnetic field that 

may damage the mechanism of a watch, or the magnetic 

identification strip on a credit or cash card, should they 

come into immediate contact with the magnets. Never 

attempt to detach or remove the electromagnetic brake! 

The electromagnetic brake is based on electromagnetic 

resistance; resistance level is electronically measured 

and shown as watt reading on the display. Due to the 

measurement system, your Tunturi ergometer need not 

be re-calibrated when assembled, serviced and used 

according to this Owner’s Manual. 

Despite continuous quality control, defects and 

malfunctions caused by individual components may 

occur in the equipment. In most cases it’s unnecessary 

to take the whole device in for repair, as it’s usually 

sufficient to replace the defective part. 

If the equipment does not function properly during use, 

contact your Tunturi dealer immediately. Always give 

the model and serial number of your equipment. Please 

state also the nature of the problem, conditions of use 

and purchase date. 

If you require spare parts, always give the model, serial 

number of your equipment and the spare part number 

for the part you need. The spare part list is at the back 

of this manual. Use only spare parts mentioned in the 

spare part list.

Please follow these instructions when carrying and 

moving the cycle about, because lifting it incorrectly 

may strain your back or risk other accidents: 

 Always switch the power off and unplug the 

power cord before you start moving the equipment 

around! 

Stand behind the equipment. Grip the seat with one 

hand and the handlebar with the other, and set your foot 

on the rear support. Tilt the equipment so that it rests 

on its transport wheels. Wheel the equipment to move 

it, on these transport wheels. Lower the equipment while 

holding on to the handlebar and remain behind the 

equipment all the time. 

 Transport the equipment 

with caution over uneven surfaces, for example over 

a step. The equipment should never be transported 

upstairs using the wheels over the steps, instead it must 

be carried. We recommend that you use a protective base 

when transporting the equipment. 

To prevent the equipment malfunctioning, store in a dry 

place with as little temperature variation as possible and 

protected from dust.

Length ..........................................95 cm

Width ..........................................62 cm

Height ..........................................135 cm

Weight .........................................38 kg
This product meets the requirements of the EU’s EMC 

Directives on electromagnetic compatibility (89/336/

EEC) and electrical equipment designed for use within 

certain voltage limits (73/23/EEC). This product 

therefore carries the CE label.

This product meets EN precision and safety standards 

(Class HA, EN-957, parts 1 and 5).

Due to our continuous policy of product development, 

Tunturi reserves the right to change specifications 

without notice. 

 The instructions must be followed carefully in 

the assembly, use and maintenance of your equipment. 

The warranty does not cover damage due to negligence 

of the assembly, adjustment and maintenance 

instructions described herein. Changes or modifications 

not expressly approved by Tunturi Oy Ltd will void the 

user’s authority to operate the equipment!