Peerless Industries SA771PU ユーザーズマニュアル

ISSUED: 10-30-09   SHEET #: 095-9299-11  03-22-12

Slide universal adapter bracket to the opposite side 
and align second display bracket with second set of 
display mounting holes.

Hand thread screws through multi-washer, display 
bracket, and spacer if used, into display as shown. 
Tighten all screws.

SCREW

MULTI-WASHER

MULTI-

WASHER

DISPLAY

DISPLAY 

BRACKET

Align one display bracket with one set of display 
mounting holes.

Begin with the shortest length screw, hand thread 
screw through multi-washer and display brackets 
into display as shown. Screw must make at least 
three full turns into the mounting hole and fi t snug 
into place. Do not over tighten. If screw cannot 
make three full turns into the display, select a longer 
length screw from the baffl ed fastener pack. Center 
display brackets vertically and tighten screws.

NOTE: For displays with a bump-out or recessed 
back, spacer may be used. Spacer goes between 
display bracket and display.

SCREW

DISPLAY

DISPLAY 

BRACKET

Center display brackets horizontally on back of display as shown in fi gure 4.3.

Tighten two 1/4-20 x 1.25" screws. Reinstall four 1/4-20 x .6" screws using 5 mm allen wrench (I) into fi xed-stop 
position 1 as shown in fi gure 4.4.

1/4-20 x 1.25" SCREWS

FIXED STOP POSITION #1 WITH 

1/4-20 x .6" SCREWS