Peerless Industries SA771PU ユーザーズマニュアル

ISSUED: 10-30-09   SHEET #: 095-9299-11  03-22-12

TILT Adjustment: Adjust tension knob on side of 
mount to desired tension to enable tilt adjustment 
and balance your display size and weight. Push 
or pull from top or bottom of display to adjust tilt 
as shown. The tilt can be adjusted to a maximum 
of 10° forward or 5° backward. Retighten tension 
knob. NOTE: For larger displays, tension screw on 
opposite side of mount may need to be tightened 
using 5/32" allen wrench (P).

Rotate display 5° clockwise or 

counter-clockwise, level display then tighten 
M5 x 10 mm roll screws using 

5 mm allen wrench (I)

as shown in detail 2.

FOR VERTICAL HEIGHT ADJUSTMENT: Tighten 
or loosen M8 x 40 mm screw to achieve ± 1" of 
vertical height adjustment as shown in detail 2.

•  Do not tighten screws with excessive force. 

•  Be careful not to pinch fi ngers when opening and 

closing mount from the wall.

TENSION KNOB

M5 X 10 MM 

SCREWS

M8 X 40 MM 

SCREW

•  M10 x 15 mm screws (E) must be securly tightened before changing orientation of wall arm assembly (A). Failure to 

lock adapter bracket can cause display to come off of mount.

FOR PORTRAIT OR LANDSCAPE DISPLAY ORIENTATION: Remove two M5 x 12mm screws, one M5 x 6mm 
screw and rotation block from top of tilt head as shown in top view and rear view. Gently grasp sides of display and 
rotate display into portrait or landscape position as shown in fi gure 6.1 and reinstall rotation block with two 
M5 x 12mm screws and one M5 x 6mm screw. NOTE: M5 x 6mm screw required in landscape orientation only.

ROTATION BLOCK

M5 X 12MM SCREWS

M5 X 6MM SCREWS

M5 X 12MM 

SCREWS

M5 X 6MM 

SCREWS

ROTATION 

BLOCK