Hitachi H8/3692 ユーザーズマニュアル

Rev. 1.0, 07/01, page 144 of 372

1. According to table 11-2, six internal/external clock signals output by prescaler S can be

selected as the timer V operating clock signals. When the operating clock signal is selected,
TCNTV starts counting-up. Figure 11-2 shows the count timing with an internal clock signal
selected, and figure 11-3 shows the count timing with both edges of an external clock signal
selected.

2. When TCNTV overflows (changes from H'FF to H'00), the overflow flag (OVF) in TCRV0

will be set. The timing at this time is shown in figure 11-4. An interrupt request is sent to the
CPU when OVIE in TCRV0 is 1.

3. TCNTV is constantly compared with TCORA and TCORB. Compare match flag A or B

(CMFA or CMFB) is set to 1 when TCNTV matches TCORA or TCORB, respectively. The
compare-match signal is generated in the last state in which the values match. Figure 11-5
shows the timing. An interrupt request is generated for the CPU when CMIEA or CMIEB in
TCRV0 is 1.

4. When a compare match A or B is generated, the TMOV responds with the output value

selected by bits OS3 to OS0 in TCSRV. Figure 11-6 shows the timing when the output is
toggled by compare match A.

5. When CCLR1 or CCLR0 in TCRV0 is 01 or 10, TCNTV can be cleared by the corresponding

compare match. Figure 11-7 shows the timing.

6. When CCLR1 or CCLR0 in TCRV0 is 11, TCNTV can be cleared by the rising edge of the

input of TMRIV pin. A TMRIV input pulse-width of at least 1.5 system clocks is necessary.
Figure 11-8 shows the timing.

7. When a counter-clearing source is generated with TRGE in TCRV1 set to 1, the counting-up is

halted as soon as TCNTV is cleared. TCNTV resumes counting-up when the edge selected by
TVEG1 or TVEG0 in TCRV1 is input from the TGRV pin.

N – 1

N + 1

N

ø

Internal clock

TCNTV input
clock

TCNTV