Harmar Mobility RPL600 ユーザーズマニュアル

 
 

 

 
 
 
Code Requirements 

Your lift has been designed to meet ASME A18.1 section 5 and CSA B44/ASME A17.5, with the 

addition of certain options. Code requirements for Vertical Platform lifts vary depending on location. 

It is the installers responsibility to contact their local code enforcement office and determine all of the 

regulations they are subject to. You must do this before installing the Vertical Platform Lift. 

•  The lift will require a 115vac 20amp grounded circuit. 
•  Outdoor Installations will require a GFI protected circuit. 
•  Only install the lift on a 4” thick , level 3,500 psi reinforced concrete slab. 
•  Foot Print 49” x 69” (this includes the folding access ramp) 

•  1/2" Hammer Drill 
•  3/8" Masonry Drill Bit 
• Appliance 

Dolly 

• Hammer 
• Level 
• Measuring 

Tape 

•  Socket Wrench Set 

•  4 Floor anchors 
Harmar recommends securing the lift using our Anchor Kit. If you purchase you own 

floor anchors they must use 3/8” bolts and have a minimum tensile strength of 6000 LBS.