Festool PI574422 ユーザーズマニュアル

8 

Domino XL DF700

The height of the fence needs to be adjusted depending on 

the type of joint being made and the thickness of the mate-

rial being joined. Refer to the ”

” section begin-

ning on 

fence height for the specific application. There are two 

features available for setting the fence height; the height 

gauge and the height stop.

  Note: It is not necessary to set the mortise height to 

be exactly in the center of a board. Attempting to do 

so can be difficult, and may actually lead to assembly 

errors. It is more important to always ensure that the 

same surface is referenced for each workpiece.

The height stop provides quick access to repeatable height 

settings. This can be especially beneficial in applications 

where you need to continually change the fence height from 

one mortise to another, such as an offset joint with a reveal 

between the pieces. 

The height gauge shows the distance between the bottom 

of the fence face and the centerline of the mortising bit. Use 

this gauge to set the mortise height relative to the surface 

of the workpiece.

  Note: Make sure to retract the Height Stop to its 

lowest setting when using the Height Gauge.

1.  Loosen the fence height locking lever by turning it ¼-turn 

counterclockwise. 

2.  To use the Height Stop:

a.  Raise the fence above the desired setting.

b.  Slide the stop in or out until the desired setting (in 

mm) is shown in the window.

c.  Lower the fence down until it touches the stop.
d.  Tighten the locking lever.

3.  To use the height gauge:

a.  Make sure the Height Stop is retracted out of the way.
b.  Raise or lower the fence until the pointer is pointing to 

the desired height on the gauge.

c.  Tighten the locking lever.

Locking 

Lever

Height 

Gauge

Height Stop 

Window

The width of the mortise slot can be increased to permit 

some side-to-side flexibility in the tenon position. The mor-

tise width lever has two positions. In the standard position, 

the Domino tenon will fit snugly into the mortise slot. In the 

wide position, the mortise slot will be 3 mm wider than the 

Domino tenon. 

  NOTICE: Never rotate the dial during a plunging 

operation. This can bend or break the mortising bit, 

and can also damage the machine.

16.5mm

13.5mm

16.5 + Ø

13.5 + Ø

Ø = Bit Diameter

Mortise 

Width Lever

Mortise Width 

Indicator