Motorola G24 ユーザーズマニュアル
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-277
S, Bit Map Registers
This command reads/writes values of the S-registers. The G24 supports this command for various
S values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
S values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
Command Type
Syntax
Response/Action
Remarks
Set
ATSn=<value
OK
or:
+CME ERROR: <err>
The Set command is allowed for
read/write S-registers, and not allowed
for read-only S-registers.
read/write S-registers, and not allowed
for read-only S-registers.
Read
ATSn?
<current value of
S-register n>
or:
+CME ERROR: <err>
Test
The Test command for Sn is not
defined by ITU, and therefore is not
supported by the G24. The G24 returns
an error.
defined by ITU, and therefore is not
supported by the G24. The G24 returns
an error.