Motorola G24 ユーザーズマニュアル
Modem Configuration and Profile
3-276
AT Commands Reference Manual
December 31, 2007
Example
ATE?
001
OK
X, Result Code Selection and Call Progress Monitoring Control
This command defines the CONNECT result code format. It determines whether or not the G24
transmits particular result codes to the user. It also controls whether the G24 verifies the presence
of dial tone when it first goes off-hook to begin dialing, and whether the engaged tone (busy
signal) detection is enabled.
transmits particular result codes to the user. It also controls whether the G24 verifies the presence
of dial tone when it first goes off-hook to begin dialing, and whether the engaged tone (busy
signal) detection is enabled.
The following table shows the X parameters.
Example
ATX?
000
OK
Command Type
Syntax
Response/Action
Remarks
Set
ATX<value>
OK
or:
+CME ERROR: <err>
The Set command sets the result code
and call progress monitoring control.
and call progress monitoring control.
Read
ATX?
<current value>
Test
The Test command for X is not defined
by ITU, and therefore is not supported
by the G24. The G24 returns an error.
by ITU, and therefore is not supported
by the G24. The G24 returns an error.
Table 3-184: X Parameters
<Parameter>
Description
<value>
0
CONNECT result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Disabled
Dial tone detection - Disabled
Busy detection - Disabled
1
CONNECT <text> result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Disabled
Dial tone detection - Disabled
Busy detection - Disabled
2
CONNECT <text> result code given upon entering online data state:
Dial tone detection - Enabled
Busy detection - Disabled
Dial tone detection - Enabled
Busy detection - Disabled
3
CONNECT <text> result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Enabled
Dial tone detection - Disabled
Busy detection - Enabled
4
CONNECT <text> result code given upon entering online data state:
Dial tone detection - Enabled
Busy detection - Enabled
Dial tone detection - Enabled
Busy detection - Enabled
The default value is 0.