Motorola MC70 ユーザーズマニュアル
6 - 2
MC70 User Guide
Troubleshooting
EDA
Table 6-1
Troubleshooting the EDA
Problem
Cause
Solution
EDA does not turn
on.
on.
Lithium-ion battery
not charged.
not charged.
Charge or replace the lithium-ion battery in the EDA.
Lithium-ion battery
not installed
properly.
not installed
properly.
Install the battery properly. See
System crash.
Rechargeable
lithium-ion battery did
not charge.
lithium-ion battery did
not charge.
Battery failed.
Replace battery. If the EDA still does not operate, perform a
warm boot, then a cold boot. See
warm boot, then a cold boot. See
EDA removed from
cradle while
battery was
charging.
cradle while
battery was
charging.
Insert EDA in cradle. The standard capacity battery (1900 mAh)
fully charges in less than four hours. The extended capacity
battery (3800 mAh) fully charges in less than eight hours.
fully charges in less than four hours. The extended capacity
battery (3800 mAh) fully charges in less than eight hours.
Cannot see
characters on
display.
characters on
display.
EDA not powered
on.
on.
Press the Power button.
During data
communication, no
data transmitted, or
transmitted data was
incomplete.
communication, no
data transmitted, or
transmitted data was
incomplete.
EDA removed from
cradle or
disconnected from
host computer
during
communication.
cradle or
disconnected from
host computer
during
communication.
Replace the EDA in the cradle, or reattach the communication
cable and re-transmit.
cable and re-transmit.
Incorrect cable
configuration.
configuration.
See the system administrator.
Communication
software was
incorrectly
installed or
configured.
software was
incorrectly
installed or
configured.
Perform setup. Refer to the MC70 Integrator Guide for details.
No sound.
Volume setting is
low or turned off.
low or turned off.
Adjust the volume. See
.