Motorola MC70 ユーザーズマニュアル
6 - 4
MC70 User Guide
Bluetooth Connection
The EDA does not
accept scan input.
accept scan input.
Scanning
application is not
loaded.
application is not
loaded.
Load a scanning application on the EDA. See the system
administrator.
administrator.
Unreadable bar
code.
code.
Ensure the symbol is not defaced.
Distance between
exit window and
bar code is
incorrect.
exit window and
bar code is
incorrect.
Place the EDA within proper scanning range.
EDA is not
programmed for
the bar code.
programmed for
the bar code.
Program the EDA to accept the type of bar code being scanned.
EDA is not
programmed to
generate a beep.
programmed to
generate a beep.
If the EDA does not beep on a good decode, set the application
to generate a beep on good decode.
to generate a beep on good decode.
Battery is low.
If the scanner stops emitting a laser beam upon a trigger press,
check the battery level. When the battery is low, the scanner
shuts off before the EDA low battery condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Symbol Technologies.
check the battery level. When the battery is low, the scanner
shuts off before the EDA low battery condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Symbol Technologies.
Table 6-1
Troubleshooting the EDA (Continued)
Problem
Cause
Solution
Table 6-2
Troubleshooting Bluetooth Connection
Problem
Cause
Solution
EDA cannot find any
Bluetooth devices
nearby.
Bluetooth devices
nearby.
Too far from other
Bluetooth devices.
Bluetooth devices.
Move closer to the other Bluetooth device(s), within a range of
10 meters.
10 meters.
The Bluetooth
device(s) nearby
are not turned on.
device(s) nearby
are not turned on.
Turn on the Bluetooth device(s) to find.
The Bluetooth
device(s) are not in
discoverable
mode.
device(s) are not in
discoverable
mode.
Set the Bluetooth device(s) to discoverable mode. If needed,
refer to the device’s user documentation for help.
refer to the device’s user documentation for help.
When trying to
connect a Bluetooth
phone and EDA, the
phone thinks a
previously paired
EDA is used.
connect a Bluetooth
phone and EDA, the
phone thinks a
previously paired
EDA is used.
The phone
remembers the
name and address
of the EDA it last
paired with via the
Bluetooth radio.
remembers the
name and address
of the EDA it last
paired with via the
Bluetooth radio.
Manually delete the pairing device and name from the phone.
Refer to the phone’s user documentation for instructions.
Refer to the phone’s user documentation for instructions.