Motorola MC70 ユーザーズマニュアル

6 - 12 MC70 User Guide

EDA battery is not 
charging.

EDA was removed 
from MSR or MSR 
was unplugged 
from AC power too 
soon.

Ensure MSR is receiving power. Ensure EDA is attached 
correctly. Confirm main battery is charging under 

. The standard capacity battery (1900 

mAh) fully charges in less than four hours. The extended 
capacity battery (3800 mAh) fully charges in less than eight 
hours.

Battery is faulty.

Verify that other batteries charge properly. If so, replace the 
faulty battery.

The EDA is not 
fully attached to 
the MSR.

Detach and re-attach the MSR to the EDA, ensuring it is firmly 
connected. 

During data 
communication, no 
data transmits, or 
transmitted data was 
incomplete.

EDA detached 
from MSR during 
communications.

Reattach EDA to MSR and retransmit.

Incorrect cable 
configuration.

See the system administrator.

Communication 
software is not 
installed or 
configured 
properly.

Perform setup as described in the MC70 Integrator Guide.

Cannot insert EDA in 
Trigger Handle.

Cleat is not 
installed on the 
EDA.

Install the cleat. Refer to the MC70 Integrator Guide.

Scan line does not 
appear when trigger 
is pressed.

EDA is not 
attached properly 
to the Trigger 
Handle and is not 
making contact 
with the connector.

Remove the EDA from the Trigger Handle and reinsert.

EDA does not 
contain a scanning 
application.

Load a scanning application on the EDA. 

Scanning 
application is not 
active.

Start the scanning application.