Motorola DTR410 ユーザーズマニュアル

9980384R89-E

November 2008

Introduction: Charging the Radio

1-7

Motorola batteries are designed specifically to be used with a Motorola charger and vice versa. 
Charging in non-Motorola equipment may lead to battery damage and void the battery warranty. The 
battery should be at about 77°F (25°C) (room temperature), whenever possible. Charging a cold 
battery (below 50° F [10°C]) may result in leakage of electrolyte and ultimately in failure of the 
battery.

Charging a hot battery (above 95°F [35°C]) results in reduced discharge capacity, affecting the 
performance of the radio. Motorola rapid-rate battery chargers contain a temperature-sensing circuit 
to ensure that batteries are charged within the temperature limits stated above.

To charge the battery, place the battery (with or without the radio) in a Motorola-approved charger.

While the radio is charging, the display lights and the battery status icon flashes to show the status. 
The battery charges in approximately 1-3 hours, and battery gauge shows all segments and stop 
flashing when fully charged.

NOTE: Use of the Drop-in Charging Tray is recommended for daily use.

1. Place the charging tray on a flat surface.
2. Connect the plug-in charger and drop-in charging tray by inserting the plug into the rear of the 

drop-in charging tray.

3. Plug the charger into an AC outlet.
4. Insert the radio (with battery installed) into the charging tray.

NOTE: The charging tray has been designed to charge the radio with or without the holster.

1. Plug the charger into an AC outlet.
2. Open the accessory connector cover.
3. Plug the other end of the charger into the accessory connector.
4. Disconnect the charger from the radio by pressing the two side buttons on the charger and 

remove from the radio.