Motorola HT 1000 ユーザーズマニュアル

37

2. Press the rubber microphone boot into its respective recessed area 

in the front cover housing. The little rubber flap in the back of the 
rubber boot should fold up to cover the microphone insertion 
opening.

3. Reinstall the speaker retainer bracket (see Figure 13).

a. Position the spring bracket over the speaker, and toward the 

top of the front cover housing; insert the appropriate two legs 
of the bracket into their respective slots. 

b. Grasp the center portion of the spring bracket (ring area) with 

thumb and forefinger.

c. While holding the ring area of the spring bracket at 

approximately the same height as the speaker’s base, push the 
remaining leg down and into its respective slot.

4. Orient the wedge connector so that its gold contacts face the gold 

contacts of the housing. Align the wedge connector with the 
respective slots in the housing, and slide the connector down into 
place. Ensure that the wedge connector is fully seated into 
position.

1.  Inset Legs

Into Slots

2.  Grasp Clip

Here and Here,Then Push Leg Into Slot

MAEPF-22578-A