Motorola HT 1000 ユーザーズマニュアル

39

are raised enough to see plating under them, 
then the flex is not fully seated.

5. Reinstall the rubber controls top seal on the control top.

Two tabs are provided in the emergency button 
area to help hold the seal in place.

Front Cover Assembly to 
Chassis

1. Install the contoured O-ring/antenna bushing seal around the 

antenna and in the groove provided (see Figure 15).

2. Orient the front cover assembly with the chassis, and insert the 

front cover/display flex connector into the locking connector of 
the controller board (refer back to Figure 6). Secure the 
connection. View the flex connection at a slight angle from the 
top of the radio and ensure that the flex connector is fully seated 
into the locking connector as illustrated in Figure 7.

3. Check to make sure that the O-ring is in place, and slide the 

chassis (control top first) into the front cover assembly. Check to 
ensure that the orange emergency button seal slides into position 
freely.

When performing the next part of this step, 
pay particular attention to the O-ring near the 
bottom of the radio to ensure that it does not 
raise up and get pinched between the front 

MAEPF-22579-A

Flex Not Fully Seated

in Connector

Flex Fully Seated

in Connector

Misaligned

Plating
Reliefs

Contoured O-ring/

Antenna Bushing Seal

MAEPF-27018-O

Contoured O-ring/

Antenna Bushing Seal

Unit with 
early Front Shield 

Unit with 
latest Front Shield