Beko DRVS 73S ユーザーズマニュアル

ページ / 28
19
EN
Changing the programme after 
it has started
You can use this feature to dry 
your clothes under higher or lower 
temperatures after your dryer has started.
For example;
1. Press and hold the “Start/Pause/
Cancel” button for about 3 seconds 
to “Cancel” the programme in order to 
select “Extra Dry” programme instead 
of “Iron Dry” programme. 
2. Select the “Extra Dry” programme 
by rotating the programme selection 
button.
3. Press “Start/Pause/Cancel” button to 
start the programme.
C
 Press “Start/Pause/Cancel” button for 
3 seconds to cancel the programme 
or turn the programme selection knob 
in any direction to end the programme 
while the machine is running. Water 
tank and filter cleaning warning lights 
turn on to warn the user when the 
programme is cancelled by pressing 
the “Start/Pause/Cancel” button for 3 
seconds. However, the warning lights 
do not turn on when the programme 
is cancelled by turning the programme 
selection knob. Only the drying light 
turns on and the machine remains in 
hold until a new programme is selected 
and the “Start/Pause/Cancel” button 
is pressed. Child-proof lock of the 
machine should not be active in order 
to perform these two operations. If the 
child-proof lock is active, deactivate it 
before performing these operations.
Adding/removing laundry in 
standby mode
In order to add or remove laundry after 
the programme starts:
1. Press the “Start/Pause/Cancel” button 
to switch the dryer to “Pause” mode. 
Drying process will stop.
2. Open the door at “Pause” position and 
close it again after adding or taking out 
laundry.
3. Press “Start/Pause/Cancel” button to 
start the programme.
C
 Any laundry added after the drying 
process has started may cause 
the dried clothes in the machine 
intermingle with wet clothes and the 
result will be wet laundry after the 
drying process is over.
C
 Laundry may be added or taken out 
as much as desired during a drying 
process, but this process will extend 
the programme duration and increase 
energy consumption since the drying 
will be interrupted continuously. 
Therefore, it is recommended to add 
laundry before the drying programme 
has started.
Child-proof lock
There is a child-proof lock to prevent 
any programme interruption due to the 
pressing of button while the programme 
is running. The loading door and all 
buttons except the “On/Off” button on 
the control panel are deactivated when 
the child-proof lock is active.
Press the “Start/Pause/Cancel” and 
“Cancel audio warning” buttons 
simultaneously for 3 seconds to activate 
the child-press lock. 
To start a new programme after the 
programme is over or to interrupt the 
programme, the child-proof lock should 
be deactivated. Press the same buttons 
for 3 sec. again to deactivate the child-
proof lock.
C
 Child-proof lock is deactivated when 
the machine is restarted by pressing 
the On/Off button.
C
Press the relevant buttons for 3 
seconds to activate the child-proof 
lock. A long beep will be heard and 
the child-proof lock will be activated. A 
double beep will be heard if you press 
any button or turn the programme 
selection knob while the child-proof 
lock is active. Press the buttons for 3 
seconds to deactivate the child-proof 
lock. Single beep will be heard and 
child-proof lock will be deactivated.
A
 A double beep will be heard if you turn 
the programme selection knob when