Samsung TL9 ユーザーズマニュアル

ページ / 95
Appendix
  84
Camera maintenance
About the battery
Use only Samsung-approved batteries.
  Battery specifications  
Mode
SLB-10A
Type
Lithium-ion battery
Cell capacity 
1050 mAh
Voltage
3.7 V
Charging time  
(when the camera is switched off)
Approx. 150 min
  Battery life  
Average time
Test conditions 
(when the battery is fully charged)
Photos
Approx. 120 min 
(Approx. 240 
photos)
Take photos under the following 
conditions: in the 
2 mode, 10M 
resolution, Fine quality, OIS on.
1.  Set the flash option to   (Fill In), take a 
single shot, and zoom in or out.
2.  Set the flash option to   (Off), take a 
single shot, and zoom in or out.
3.  Perform steps 1 and 2 for 30 seconds 
and repeat for 5 minutes. Then turn off 
the camera for 1 minute.
4. Repeat steps 1 to 3.
Videos
Approx. 120 min
Record videos at 640x480 resolution and 
30 fps.
Average time
Test conditions 
(when the battery is fully charged)
MP3
Approx. 310 min
Play files with the screen turned off.
PMP
Approx. 230 min
Play files with normal playback.
The figures above are measured by Samsung’s standards and may differ 
depending on usage.
  Notes about charging the battery  
If the indicator light is off, make sure that the battery is inserted 
correctly.
Turn off your camera when charging.
Turn on your camera after charging the battery for more than 10 
minutes. 
Using flash or recording videos uses up the battery quickly. Charge 
the battery until the indicator light turns green.
If the indicator light blinks in red or is off, reconnect the cable or 
remove the battery and insert it again.
If you charge the battery when it is warm, the indicator light may turn 
orange. Charging will start when the battery cools down.
  Notes about charging with a computer connected  
Use the provided USB cable only.
The battery may not be charged when: 
-  you use a USB hub 
-  other USB devices are connected to your computer 
-  you connect the cable to the port on the front side of your  
    computer 
-   the USB port of your computer does not support the Power output 
standard (5 V, 500 mA)