Concord Camera 5040 ユーザーズマニュアル

14

1.  Make sure the camera is in still image shooting mode ( 

).

2.  Frame the subject in the LCD.
3.  Press the Shutter button fully down to capture the image.

 The camera provides up to 4x digital zoom. 
 
1.  Press   to zoom in subject for a telephoto shot.

•   The zoom indicator shows the current approximate zoom factor.

2.  Press   to zoom out for a wide angle shot.

Use the flash according to the guidelines below.

 

Auto

The camera judges if a flash is required. If the environment is 
too dark, the flash will fire.

 

Force On

The flash always fires.

 

Force Off

The flash does not fire.

1.  Press 

 to switch between flash modes.

•  The selected flash mode icon appears on the LCD monitor.

2.  Shoot the image.

Note: 
1.  The indicator beside the Power button will blink in red when the camera is charging the Flash. Wait
 

until the indicator stops blinking then to take a flash picture. 

2.  When batteries are low, the Flash will be disabled. If you found that the Auto Flash ( 

 ) or Force 

Flash ( 

 ) cannot be activated by pressing 

 , replace or recharge the batteries.

The current approximate 
zoom factor

TAKING PICTURES