Zebra Technologies radio frequency identification (rfid) ユーザーズマニュアル
SGD Commands for RFID
rfid.error.response
rfid.error.response
134
58978L-008 Rev. A
RFID Programming Guide
11/14/2008
rfid.error.response
Description During an error condition, an error message shows on the second line of the
display. This command can be used to retrieve that error message. See
display. This command can be used to retrieve that error message. See
the RFID Troubleshooting section for descriptions of the error messages.
Type getvar
\
This table identifies the command for this format:
Commands
Details
getvar
This command instructs the printer to respond with any active RFID error
messages.
messages.
Format: ! U1 getvar "rfid.error.response"
Example •
This getvar example shows responses that you may get in different situations:
! U1 getvar "
rfid.error.response
"
If no RFID tag is present, you get the following response:
NO TAG FOUND
If an RFID tag is present and there are no errors, you get the following response:
RFID OK