Oce North America 500XL ユーザーズマニュアル
LightJet 500XL Maintenance Guide
×
see copyright, disclosure, use and duplication information on pg ii
48058-A
3-4
Error 06 – Micropositioner Location Unknown
Possible
Cause:
Cause:
Micropositioner has lost servo.
Recovery
Method:
Method:
Select Media/Cut and Unload. If problem persists, contact Océ.
Error 07 – Media Guide Stuck at Home
Possible
Causes:
Causes:
A) Media guides are stuck in their parked position.
B) Mechanical component failure.
Recovery
Methods:
Methods:
A) Select Media/Cut and Unload. Inspect media guides. Clear physical
obstruction if present.
B) Contact Océ.
Error 10 – Outfeed Timeout Fault
Possible
Cause:
Cause:
The bottom-of-drum sensor did not sense any media within 30 seconds.
Recovery
Method:
Method:
Select Set Up/Motor Control/All Motors Reverse. Retract 150 inches of media.
If error persists, contact Océ.
If error persists, contact Océ.
Communication Failures
Problems that prevent proper communication between the LightJet
®
500XL and the host
computer can cause total loss of communication, prevent certain functions, or corrupt the data
used to generate the image. The LightJet
used to generate the image. The LightJet
®
500XL cannot detect:
§ Whether the host computer is unable to generate the proper commands.
§ Some cases of data corruption.
§ When a SCSI cable is bad or disconnected.
§ When the wrong SCSI ID has been selected.
Notes:
1
The LightJet 500XL can detect some, but not all, types of data corruption.
2
The LightJet 500XL is shipped from the factory with the SCSI ID set to 6 (binary 110).