Panasonic AWRP120GJ ユーザーズマニュアル
19
Operating tracing memory (TMEM)
(continued)
7 .
Press START button [11] .
The indicator of START button [11] turns on. (Operation wait state)
TM05:
Waiting Opr.
Waiting Opr.
8 .
Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons .
The recording of tracing memory starts from the point in time that the
operation began.
z
To record the focus operation and iris operation, press the focus
button and auto iris button to turn off their indicators and then
perform the operations.
TM05:0m02s
Storing.
Storing.
Recording time
9 .
Press STOP button [12] .
Recording stops and the tracing memory is saved.
The registered number button turns on and the status returns to that
of step 3.
z
When the possible recording time elapses, recording stops
automatically.
At that time, operations up until the point in time that recording
stops are recorded.
Recalling tracing memory (RECALL)
1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Press the TMEM button to turn on its indicator .
The tracing memory status appears.
The indicators of number buttons with registered tracing memory
turn on.
CAM1 TMEM
3m50s Remained.
3m50s Remained.
Selected camera number
Remaining possible recording time (max . 5 m 00 s)
z
A button with no tracing memory registered does not turn on
even when it is a button with preset memory registered.
Note
3 .
Press one of the number buttons that has its indicator
turned on to specify the tracing memory number .
The remote camera moves to the start position.
The indicators of the number button that was pressed and START
button [11] blink. (Recall standby state)
TM03:0m00s
/0m59s
Standby Recall.
4 .
Press START button [11] .
The tracing memory is recalled and the remote camera starts
moving.
The indicator of START button [11] turns on.
TM03:0m20s
/0m59s
Recalling.
Tracing memory number
Current recall
position
Total time of tracing
memory during recalling
5 .
When the recording time elapses, the remote camera
stops automatically .
The number button that was blinking turns on, the indicator of
START button [11] turns off, and the process returns to step 2.
z
When STOP button [12] is pressed during recalling, recalling stops
and the process returns to step 2.