Panasonic AWRP120GJ ユーザーズマニュアル
21
Operating tracing memory (TMEM)
(continued)
7 .
Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons to make a correction .
Only the data for which the operation was performed is overwritten
from the point in time that correction operation was performed.
z
Tracing data cannot be partially restored.
After starting the tracing data restore operation, be sure to
perform the operation all the way to the end.
Note
8 .
When the recording time elapses, the remote camera
stops automatically .
The process returns to step 3.
z
When STOP button [12] is pressed during recalling, recalling
stops.
The total time of the tracing memory changes, and the process
returns to step 3.
Setting the items to recall when recalling
tracing memory
You can select whether to recall all or only some of the items registered
to tracing memory.
1 .
Press the MEM SETTING button to turn on its indicator .
The current setting appears.
SPEED : ———
SCOPE : MODE A
SCOPE : MODE A
2 .
Turn the F2 dial to select a setting for the “SCOPE” item
from MODE A to MODE C, and then press the F2 dial to
confirm the selection .
z
The setting of the unit is changed.
This is is applied the next time the tracing data is recalled.
<SCOPE settings and recalled items>
Setting
Recalled item
Pan, tilt, zoom,
and focus
Iris
White balance
mode
MODE A
√
√
√
MODE B
√
√
—
MODE C
√
—
—
√: Recalled —: Not recalled
When the operation is performed, the PRESET SCOPE setting of
the remote camera is changed to the same setting as well at the
same time.
⇒ “Setting the operation items for when preset memory is recalled
(PRESET SCOPE)” (page 15)