Avaya 03-300430 ユーザーズマニュアル

1003

ABRT

The system could not allocate a tone receiver for the test. The system may 
be oversized for the number of Tone Detectors present or some Tone 
Detectors may be out of service.

1. Enter display errors and follow associated repair procedures for 

TTR-LEV. Even if there are no TTR-LEV errors, there may not be a 
Tone Detector available on the network that contains the circuit pack 
being tested. Verify that there is at least one Tone Detector on this 
network. If there is not at least one Tone Detector, this test always 
aborts for this EI board. This will not harm the system.

2. Enter display errors and follow associated repair procedures for 

TONE-PT.

3. If neither condition exists, retry the command at 1-minute intervals up 

to 3 times.

1015

ABRT

The system will not allow this test to be run because the EI circuit pack has 
not been busied out.

1. Busyout the EI circuit pack. Repeat test board location long.

1031

ABRT

If the EI circuit pack is in a PN and is on the active PNC, and is not part of a 
PN-to-PN link, this test cannot be executed. If the lightwave transceiver 
looparound is activated, it is impossible to deactivate it.

1. If PNC Duplication is enabled, attempt to make the standby PNC active 

through reset pnc interchange.

2. If the PNC Interchange is successful, the Lightwave Transceiver 

Looparound test may now be executed on the original EI circuit pack.

1033

ABRT

The test cannot run because the EI circuit pack does not have a fiber link 
administered to it and there is not sufficient data to run the test.

1. Enter list fiber-link to verify that there is no fiber link 

administered to this circuit pack.

2. If there is no fiber administered to this circuit pack (but should be), add 

the correct fiber using add fiber-link.

3. Retry the command.

 2 of 6