Bosch 00P ユーザーズマニュアル

Bosch Security Systems

10 October 2003

Figure 5 Placement of Pole on Pad

  3.     Insert the wiring into the 3" diameter hole in the base of the 
          pole. Be sure all slack is pulled completely through.  

  4.     Insert connecting wiring into the bottom access opening, run
          through the pole up to the top access opening. Insert the end
          rough the housing connecting hole.  Close the top access 
          opening and make necessary wiring connections at the bottom 
          access opening (Figure 6).

Access opening plates

Pad

Bolts or 
anchor jig

Top access opening

Figure 6 Connecting Wiring Through Pole

  5.     Slowly lift the pole into the upright position, aligning 
          the holes of the Base Plate with the Bolts in the concrete 
          pad (FigurBosch Security Systems10 October 2003e 7).

Figure 7 Lifting the Pole into Position

CAUTION:  Pull all slack in the wiring as you lift the pole into 
position to keep from pinching and possible damage.

Figure 8 Securing the Pole to the Pad

  6.     Ensure that the pole is vertical on all sides.  Use a         
          bubble level or plumb bob to check.  

  7.     Secure the pole to the pad with fasteners (Figure 8).

Nut

Lock Washer

Flat Washer

  1.     Align the holes of the AutoDome adapter plate with the 
          holes on the mounting plate at the top of the pole 
          (Figure 9).