Honeywell EN2H-0221GE51 R0808 ユーザーズマニュアル

Operation 

SDC / DHC  

24 EN2H-0221GE51 

R0808 

By pressing once, you can: 

•  Confirm input / values 

 

By pressing and holding (approx. 3 s), you can: 

•  Switch to the menu-selection level 

•  Move up one menu level 

 

By turning the input button 

î

, you can: 

•  Change values (clockwise increases called-up values, 

anticlockwise decreases them) 

•  Navigate through menus 

 

Sets the desired room temperature (room setpoint) in automatic 
mode during the heating cycles and in the PARTY and HEATING 
operating modes. In operating mode 1, the set value for all 
heating circuits is the same. In operating mode 2, the set value 
applies for the respective heating circuit. To set the operating 
mode, see 5.2.3.3 Operating mode, pg. 74. 

 

► Press 

¥

 button. 

►  Set flashing room temperature specification to the desired 

value by turning the input button 

î

. 

►  Confirm set value by pressing the 

¥

 button or the input 

button 

î

. 

Alternative: Automatic acceptance of the value after the set 
information time (see  5.1.2.7 "System information" button, pg. 35). 

 

20 °C 

 

5 ... 30 °C 

 

ð

¥

C