Desa RCLP100V ユーザーズマニュアル

www.desatech.com

103908-01E

5

OPERATION

WARNING: Review and un-

derstand the warnings in the

Safety Information section, page

2. They are needed to safely op-

erate this heater. Follow all local

codes when using this heater.

TO START HEATER

1. Follow all installation, ventilation and safety

information.

2. Locate heater on stable and level surface.

Make sure strong drafts do not blow into front

or rear of heater.

3. Make sure the control knob is in the OFF

position.

5. Check all connections for leaks.
6. Close propane supply valve.

INSTALLATION

Continued

Figure 3 - Regulator With Vent Pointing

Down

Hose

Regulator

Vent
(pointing
down)

Fuel Gas
Connector

Supply Valve

Propane
Tank

Figure 4 - Hose and Inlet Connector

Hose

100,000 Btu/Hr
Model Shown

Inlet
Connector

4. Plug power cord of heater into a three-prong,

grounded extension cord. Extension cord must

be at least 6 ft. (2 m) long, UL/CSA listed, and

of a proper size.

Extension Cord Size Requirement

Up to 100 ft. (30 m) long, use 16 AWG rated

cord.

101 to 200 ft. (31 to 60 m) long, use 14 AWG

rated cord.

5. Plug extension cord into a 120 volt/60 hertz,

3-hole, grounded outlet. Motor will start. Fan

will turn, forcing air out front of heater.

6. Open propane supply valve on propane tank(s)

slowly. Note: If not opened slowly, excess-

ﬂow check valve on propane tank will stop

gas ﬂow. If this happens, close propane supply

valve and open again slowly.

7. Press and hold in control knob. Turn counter-

clockwise to the LOW position. Heater should

ignite within a few seconds.

Note:

If heater fails to ignite, hose may have

air in it. If so, keep automatic control valve

button pressed and wait 20 seconds. Release

automatic control valve button and wait 20

seconds for unburned fuel to exit heater.

Repeat step 7.

8. After heater ignites, wait 30 seconds then

release the control knob. This activates the

automatic control system.

9. When burner remains lit, set heater at the

desired heat level by turning the control valve

counterclockwise. If burner goes out, turn off

gas. Turn control knob fully clockwise to the

lowest position. Check fuel supply. If adequate

fuel is available, restart heater beginning at

step #1.

TO STOP HEATER

1. Tightly close propane supply valve on propane

tank(s).

2. Wait a few seconds. Heater will burn gas left

in supply hoses.

3. Turn control knob to the OFF position.
4. Unplug heater.