Desa CB36P ユーザーズマニュアル
www.desatech.com
117437-01D
5
LOGS
• If you remove logs for cleaning, refer to
Installing Logs and Glowing Embers, page
19, to properly replace logs.
19, to properly replace logs.
• Use a vacuum cleaner to remove any
carbon.buildup.on.logs.
•. Replace.log(s).if.broken..See.Replacement
Parts,.page.31.
•. Replace. ember. material. periodically. as.
needed..See.Replacement Parts, page 31.
VENTING SYSTEM
Conduct. annual. inspection. of. the. venting.
system.following.these.guidelines:
1.. Check.areas.of.venting.system.that.are.
system.following.these.guidelines:
1.. Check.areas.of.venting.system.that.are.
exposed. to. the. weather. corrosion. (rust.
CLEANING AND MAINTENANCE
Continued
spots or streaks and in extreme cases,
holes).. Have. these. items. replaced. im-
mediately by a qualified service person.
holes).. Have. these. items. replaced. im-
mediately by a qualified service person.
2. Remove the vent cap and shine a flashlight
into.vent..Remove.any.foreign.material.
3.. Check. for. evidence. of. excessive. con-
densation..Continuous.condensation.can.
cause corrosion of caps, pipes and fittings
and.can.be.caused.by.having.excessive.
lateral runs, too many elbows or exterior
portions.of.the.system.being.exposed.to.
cold.weather.
cause corrosion of caps, pipes and fittings
and.can.be.caused.by.having.excessive.
lateral runs, too many elbows or exterior
portions.of.the.system.being.exposed.to.
cold.weather.
4. Inspect joints to verify that no pipe sec-
tion or fitting has been distributed and
loosened.. Check. mechanical. supports.
such.as.wall.straps.for.rigidity.
loosened.. Check. mechanical. supports.
such.as.wall.straps.for.rigidity.
SPECIFICATIONS
(V)CB36N
• Maximum Input Rating: 18,000 Btu/hr
•. Gas.Type:.Natural
• Orifice Size (Main Burner): #45 DMS
•. Gas.Type:.Natural
• Orifice Size (Main Burner): #45 DMS
(0.08")
•. Ignition:.Millivolt
•. Manifold.Pressure:.3.5".w.c..(0.87.kPa)
•. Min..Inlet.Supply.Pressure:.5.5".w.c..(1.1.kPa)
•. Manifold.Pressure:.3.5".w.c..(0.87.kPa)
•. Min..Inlet.Supply.Pressure:.5.5".w.c..(1.1.kPa)
(V)CB36P
• Maximum Input Rating: 18,000 Btu/hr
•. Gas.Type:.Propane/LP
• Orifice Size (Main Burner): #55 DMS
•. Gas.Type:.Propane/LP
• Orifice Size (Main Burner): #55 DMS
(0.05")
•. Ignition:.Millivolt
•. Manifold.Pressure:.10".w.c..(.5.kPa)
•. Min..Inlet.Supply.Pressure:.11".w.c..(.7.kPa)
•. Manifold.Pressure:.10".w.c..(.5.kPa)
•. Min..Inlet.Supply.Pressure:.11".w.c..(.7.kPa)
(V)CB36NE
• Maximum Input Rating: 18,000 Btu/hr
•. Gas.Type:.Natural
• Orifice Size (Main Burner): #45 DMS
•. Gas.Type:.Natural
• Orifice Size (Main Burner): #45 DMS
(0.08")
•. Ignition:.Electronic
•. Manifold.Pressure:.3.5".w.c..(0.87.kPa)
•. Min..Inlet.Supply.Pressure:.5.5".w.c..(1.1.kPa)
•. Manifold.Pressure:.3.5".w.c..(0.87.kPa)
•. Min..Inlet.Supply.Pressure:.5.5".w.c..(1.1.kPa)
(V)CB36PE
• Maximum Input Rating: 18,000 Btu/hr
•. Gas.Type:.Propane/LP
• Orifice Size (Main Burner): #55 DMS
•. Gas.Type:.Propane/LP
• Orifice Size (Main Burner): #55 DMS
(0.05")
•. Ignition:.Electronic
•. Manifold.Pressure:.10".w.c..(.5.kPa)
•. Min..Inlet.Supply.Pressure:.11".w.c..(.7.kPa)
•. Manifold.Pressure:.10".w.c..(.5.kPa)
•. Min..Inlet.Supply.Pressure:.11".w.c..(.7.kPa)
ALL MODELS
• Fireplace Dimension HxWxD (Actual size of firebox measurements do not include nailing
flanges or standoffs): 35.75" x 36.25" x 14.75" (90.8 x 92.1 x 37.5 cm)
•. Carton.Dimension.HxWxD:.36.75".x.38".x.16.5".(93.3.x.96.5.x.41.3.cm)
SERVICE HINTS
When Gas Pressure Is Too Low
•. pilot.will.not.stay.lit
•. burners.will.have.delayed.ignition
• heater will not produce specified heat
• for propane/LP units, propane/LP gas sup-
•. pilot.will.not.stay.lit
•. burners.will.have.delayed.ignition
• heater will not produce specified heat
• for propane/LP units, propane/LP gas sup-
ply.may.be.low
You.may.feel.your.gas.pressure.is.too.low..If.
so, contact your local natural or propane/LP
gas.supplier.
so, contact your local natural or propane/LP
gas.supplier.
TECHNICAL SERVICES
You.may.have.further.questions.about.installa-
tion, operation, or troubleshooting. If so, con-
tact DESA Heating, LLC at 1-866-672-6040.
When. calling. please. have. your. model. and.
serial.numbers.of.your.heater.ready.
You can also visit DESA Heating, LLC’s web
site.at.
tion, operation, or troubleshooting. If so, con-
tact DESA Heating, LLC at 1-866-672-6040.
When. calling. please. have. your. model. and.
serial.numbers.of.your.heater.ready.
You can also visit DESA Heating, LLC’s web
site.at.
www.desatech.com
.