Wayne-Dalton 5120 ユーザーズマニュアル

Tools Needed:

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. 

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at 

Install the side lock on the second 
section of the door. secure the lock to 
the section with (4) 1/4”- 20 x 11/16” 
self drilling screws. square the lock 
assembly with the door section and 
align with the square hole in the vertical 
track. The side lock should be spaced 
in approximately 1/8” from the section 
edge.

IMPORTANT: sIDE lOCks MusT BE 

REMOVED OR MaDE INOPERaTIVE IN 

ThE uNlOCkED POsITION IF aN 

OPERaTOR Is INsTallED ON ThE DOOR.

NOTE: after completing this step, 

continue with step 8 on page 15.

�

(4) 1/4”- 20 x 11/16” 

sElF DRIllING sCREWs

1/8”

Power Drill

7/16” socket 

Driver

NOTE: When installing a DoorMaster

TM

 

operator use the center bracket and 

drive gear supplied with your operator 

(located in DoorMaster

TM

 package). 

slide the DoorMaster

TM 

bracket/drive 

gear assembly onto the TorqueMaster

®

 

spring tube, so that the drive gear/center 

bracket assembly are in the center of 

the TorqueMaster

®

 spring tube. 

NOTE: after completing this step, 

continue with step 18 on page 22.

None

�

CENTER 

BRaCkET 

BushING 

assEMBly

TORquEMasTER

®

 TuBE

DOORMasTER

TM 

 BRaCkET/ 

DRIVE GEaR assEMBly 

To locate the center bracket, mark the 
header halfway between the flagangles 
and level the TorqueMaster

®

 spring tube. 

Drill 1/8” pilot holes into header for the 
lag screws. Fasten the metal bracket to 
the header using (2) 1/4” x 1-1/2” lag 
screws.

NOTE: after completing this step, 

continue with step 27 on page 28.

Tools Needed:

Power Drill

1/8” Drill Bit

7/16” socket 

Driver

(2) 1/4” x 1-1/2” 

hEx hEaD laG 

sCREWs