Wayne-Dalton 5120 ユーザーズマニュアル

Tools Needed:

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. 

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at 

Make one mark 1” (25 mm) up from 
the center of bottom edge of the bottom 
section and another mark 2-3/16” (56 mm) 
up from the first mark. 

Drill a 7/16” (11 mm) hole through the 
section at each mark and insert the outside 
step plate. 
 
loosely fasten step plate slide to base with 
(1) 1/4” - 20 x 5/8” carriage bolt and nut. 

align inside step plate holes and fasten 
from inside using the #8 screws provided. 
Install one #8 x 3/4” screw in the bottom 
step plate hole. The screw in the top hole 
varies with door models. 

use the screw size shown below for your 
model door.

a) #8 x 3/4” screw for Model 5120
b) #8 x 1” screw for Model 5140

Tighten 1/4” - 20 carriage bolt and nut.

DO NOT INsTall Pull ROPEs 

ON DOORs WITh ElECTRIC 

OPERaTORs. ChIlDREN May 

BECOME ENTaNGlED IN ThE 

ROPE CausING sEVERE OR FaTal 

INjuRy.

Measure and mark the jamb 

approximately 48” to 50” (1220 to 1270 

mm) from floor on the right or left side of 

door. Drill 1/8” pilot hole for No. 6 screw 

eye.  Tie the pull rope to the No. 6 screw 
eye and to the bottom bracket as shown.

sTEP PlaTE INsIDE

NO. 6 sCEW EyE

Pull ROPE

BOTTOM BRaCkET

Pull ROPE

7/16” Drill Bit

Power Drill

7/16" Wrench

�

�

(2) #8 sCREWs

assEMBlED 

sTEP PlaTE

1/4” - 20 x 5/8” 
CaRRIaGE BOlT

hEx NuT

sTEP PlaTE 

BasE

sTEP PlaTE 

slIDE

Power Drill

1/8” Drill Bit

sTEP PlaTE OuTsIDE

1” (25

mm

)

2 3/16”

 

(56

mm

)