Chamberlain WD962KPEV ユーザーズマニュアル

21

Compatible with MyQ™ and Security✚

 

2.0™ 

accessories. NOTE: Older Chamberlain 
accessories and third party products are not 
compatible.

Your garage door opener is compatible with 
up to 2 Security✚

 

2.0™ door controls. 

Install the door control within sight of the 
door at a minimum height of 5 feet (1.5 m) 
where small children cannot reach, and away 
from the moving parts of the door.

To prevent possible SERIOUS INJURY or DEATH from electrocution:
•   Be sure power is NOT connected BEFORE installing door control.
•   Connect ONLY to 24 VOLT low voltage wires. 
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
•   Install door control within sight of garage door, out of reach of children at a minimum 

height of 5 feet (1.5 m), and away from ALL moving parts of door.

•   NEVER permit children to operate or play with door control push buttons or remote 

control transmitters.

•   Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no 

obstructions to door travel.

•   ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to 

cross path of closing garage door.

Screw
6ABx1-1/2" (2)

Drywall 
Anchors (2)

Screw
6-32x1" (2)

Screw
6ABx1-1/4" (2)

Strip 7/16 inch (11 mm) of 
insulation from one end of the wire 
and separate the wires.

7/16" 
(11 mm)

Connect one wire to each of the 
two screws on the back of the 
door control. The wires can be 
connected to either screw.

Mark the location of the bottom 
mounting hole and drill a 5/32 inch 
(4 mm) hole.

Install the bottom screw, allowing 
1/8 inch (3 mm) to protrude from 
the wall.

PRE-WIRED INSTALLATIONS: Choose any 
two wires to connect, but make note of which 
wires are used so that the correct wires are 
connected to the garage door opener in a 
later step.

6-32x1"

6ABx1-1/2"

Drywall Anchor