Chamberlain WD962KPEV ユーザーズマニュアル

30

Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a 
closing garage door.
•   Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system. 
•   After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with 1-1/2" (3.8 cm) high 

object (or 2x4 laid fl at) on fl oor.

1.1   

Press and hold the Adjustment 
Button until the UP Button begins 
to fl ash and/or a beep is heard.

1.2   

Press and hold the UP Button 
until the door is in the desired 
UP position  

1.3   

Once the door is in the desired 
UP position press and release the 
Adjustment Button. The garage door 
opener lights will fl ash twice and the 
DOWN Button will begin to fl ash.

1.4   

Press and hold the DOWN Button 
until the door is in the desired 
DOWN position.

1.5   

Once the door is in the desired 
DOWN position press and release 
the Adjustment Button. The garage 
door opener lights will fl ash twice 
and the UP Button will begin to 
fl ash.

1.6   

Press and release the UP Button. 
When the door travels to the 
programmed UP position, the 
DOWN Button will begin to fl ash.

1.7   

Press and release the DOWN 
Button. The door will travel to the 
programmed DOWN position. 
Programming is complete.

*  If the garage door opener lights are 

fl ashing 5 times during the steps for 
Program the Travel, the programming 
has timed out. If the garage door opener 
lights are fl ashing 10 times during the 
steps for Program the Travel, the safety 
reversing sensors are misaligned or 
obstructed (refer to page 28). When the 
sensors are aligned and unobstructed, 
cycle the door through a complete up and 
down cycle using the remote control or 
the UP and DOWN buttons. Programming 
is complete. If you are unable to operate 
the door up and down, repeat the steps for 
Programming the Travel.