Chamberlain WD962KPEV ユーザーズマニュアル

32

1.1 

Unplug the garage door opener.

1.2   

Open the light lens on the right side panel of the garage door opener. Use a 
Phillips head screwdriver to remove the battery cover on the garage door opener.

Partially insert the battery into the battery compartment with the terminals 
facing out.

1.4   

Connect red (+) and black (-) wires from the garage door opener to the 
corresponding terminals on the battery.

1.5 

Verify the battery wires are seated in the channel and replace the battery cover.

1.6 

Plug in the garage door opener.

1.7   

Wait for the green Battery Status LED to start fl ashing before proceeding to test 
the battery.

Channel

To reduce the risk of FIRE or INJURY to 
persons:
•   Disconnect ALL electric and 

battery power BEFORE performing 
ANY service or maintenance.

•   Use ONLY Chamberlain part 

# 41A6357-1 for replacement battery.

•   DO NOT dispose of battery in fi re. 

Battery may explode. Check with local 
codes for disposal instructions.

2.1   

Unplug the garage door opener. The 
battery status LED will either glow 
solid orange indicating opener is 
operating on battery power or will 
fl ash indicating low battery power.

2.2   

Open and close the door using the 
remote control or door control.

2.3   

Plug in the garage door opener. 
Verify the battery status LED is 
fl ashing green, indicating the battery 
is charging.

Battery 

Status LED

ALWAYS wear protective gloves and 
eye protection when changing the 
battery or working around the battery 
compartment.