Chamberlain WD962KPEV ユーザーズマニュアル
6
Assemble the rail and trolley
Assembly
1
To prevent INJURY from pinching, keep
hands and fi ngers away from the joints
while assembling the rail.
hands and fi ngers away from the joints
while assembling the rail.
1.1
Carefully remove the straight door arm
and hanging brackets packaged inside
the front rail.
and hanging brackets packaged inside
the front rail.
1.2
Align the rails on a fl at surface as
shown. The front rail has a cut out
window near the end. Make sure that
the larger hole on the front rail is
facing up.
shown. The front rail has a cut out
window near the end. Make sure that
the larger hole on the front rail is
facing up.
1.3
Slide the tapered end of each rail
section into the larger end of the rail
section in front of it. The tabs along
the side will lock in place. All holes in
the rail sections should face up.
section into the larger end of the rail
section in front of it. The tabs along
the side will lock in place. All holes in
the rail sections should face up.
1.4
Insert a screwdriver into the hole
shown (this will temporarily keep the
trolley from sliding off the end of the
rail).
shown (this will temporarily keep the
trolley from sliding off the end of the
rail).
1.5
Check to make sure that the 4 plastic
wear pads are inside the inner trolley.
If they are missing check all the
packing material and snap them back
into place.
wear pads are inside the inner trolley.
If they are missing check all the
packing material and snap them back
into place.
1.6
Slide the trolley along the rail toward
the screwdriver.
the screwdriver.
Trolley
Wear Pads