Vermont Casting 3225 ユーザーズマニュアル

ページ / 44
21
Radiance Direct Vent /Natural Vent Gas Heater
20004188
LG156
Radiance logs
4/23/01  djt
LG156
Fig. 39  Install the left and right rear logs and the right log.
Decorative 
Grate
Right Log
Right Rear Log
Left Rear Log
Left Bracket
Right 
Bracket
4.  Install the right log by engaging hole on the bottom 
with pin on the right rear log. (Fig. 40) Set the bottom 
of the log on the bracket and bring forward to come 
in contact with decorative grate on right.
5.  Loosely sprinkle the lava rocks directly on top of the 
burner just behind decorative grate. (Fig. 41) Use 
the lava rock to cover brackets on the burner. Do 
not place lava rocks toward back of burner. The lava 
rock is shipped inside the bag assembly.
Connect the Gas Supply Line
Check the Rating Plate attached by a steel cable to the 
firebox, to confirm that you have the appropriate firebox 
for the type of fuel to be used. The Radiance may be 
converted from one gas to another using the appropri-
ate Fuel Conversion Kit listed on page 30.
In the U.S.; Gas connection should be made in ac-
cordance with current National Fuel Gas Code, ANSI 
Z223.1/NFPA 54. Since some municipalities have addi-
tional local codes, be sure to consult your local authority.
In Canada; consult the local authority and CSA-B149.1 
installation code.
Always check for gas leaks with a mild 
soap and water solution. Do not use an 
open flame for leak testing.
Light the pilot according to the directions on Page 24, 
before going to the next step.
LG155
Radiance logs
installed
4/24/01  djt
LG155
Fig. 40  Completed log installation.
Lava Rock
Log rests on 
decorative grate
LG160
RNV logs
top view
6/4/01   djt
Left Rear Log
Right Rear 
Log
Lava rock may 
be placed in 
this area
Decorative Grate
Top View
Fig. 41  Lava rock placement.
LG160
LG156
Radiance logs
4/23/01  djt
Rear Log 
Bracket
LG158
Fig. 38  Radiance firebox.