Hearth & Home Technologies Bravo ユーザーズマニュアル

Hearth & Home Technologies  •  Bravo, Aztec  •  InD  •  703-900  Rev. N  •  8/06

10

A  

=  12 inches ...............clearances above grade, veranda, 

porch, deck or balcony

B = 

12 

inches 

...............clearances to window or door 

that may be opened, or to perma-
nently closed window. (Glass)

D* 

=  18 inches ...............vertical clearance to unventilated 

soffi t or to ventilated soffi t located 
above the terminal

 

    *30 inches ..............for vinyl clad soffi ts and below 

electrical service 

F 

=   9 inches ................clearance to outside corner

G 

=  6 inches .................clearance to inside corner

H 

=  3 ft. (Canada) ........not to be installed above a gas 

meter/regulator assembly within 3 
feet (90cm) horizontally from the 
center-line of the regulator

I 

=  3 ft. (U.S.A.)

 

 

6 ft. (Canada) .........clearance to gas service regulator 

vent outlet

J 

=  9 inches (U.S.A.)

 

 

12 inches (Canada) clearance to non-mechanical 

air supply inlet to building or the 
combustion air inlet to any other 
appliance

K 

=  3 ft. (U.S.A.)

 

 

6 ft. (Canada) ...........clearance to a mechanical 

(powered) air supply inlet

L** = 7 

ft. 

..........................c l e a r a n c e   a b o v e   p a v e d 

sidewalk or a paved driveway 
located on public property

M*** =  18 inches.................clearance under veranda, porch, 

deck, balcony or overhang

  

42 

inches 

................vinyl 

  **  a vent shall not terminate directly above a sidewalk or paved driveway 

which is located between two single family dwellings and serves both 
dwellings.

 ***  only permitted if veranda, porch, deck or balcony is fully open on a 

minimum of 2 sides beneath the fl oor, or meets Note 2.

NOTE 1: On private property where termination is less than 7 feet above 
a sidewalk, driveway, deck, porch, veranda or balcony, use of a listed cap 
shield is suggested. (See vents components page)

NOTE 2: Termination in an alcove space (spaces open only on one side 
and with an overhang) are permitted with the dimensions specifi ed  for 
vinyl or non-vinyl siding and soffi ts.  1. There must be 3 feet minimum 
between termination caps. 2.   All mechanical air intakes within 10 feet 
of a termination cap must be a minimum of 3 feet below the termination 
cap. 3. All gravity air intakes within 3 feet of a termination cap must be a 
minimum of 1 foot below the termination cap.

NOTE 3: Local codes or regulations may require different 
clearances.

NOTE 4: Termination caps may be hot. Consider their proximity to 
doors or other traffi c areas.

NOTE 5: Location of the vent termination must not interfere with 
access to the electrical service.

WARNING: In the U.S: Vent system termination is NOT permitted in 
screened porches. You must follow side wall, overhang and ground 
clearances as stated in the instructions.

In Canada: Vent system termination is NOT permitted in screened 
porches. Vent system termination is permitted in porch areas with 
two or more sides open. You must follow all side walls, overhang 
and ground clearances as stated in the instructions.

Hearth & Home Technologies assumes no responsibility for the 
improper performance of the appliance when the venting system 
does not meet these requirements.

N 

=  6 inches ..................non-vinyl sidewalls

 

 

12 inches ................vinyl sidewalls

P = 

8 

ft.

S  =   6 inches ...................clearance from sides of elec-

trical service

T = 12 

inches 

..................clearance above electrical 

service

 

  1 cap 

  3 feet 

   2 x Q 

ACTUAL

  2 caps 

  6 feet 

   1 x Q 

ACTUAL

  3 caps 

  9 feet 

2/3 x Q 

ACTUAL

  4 caps 

12 feet 

1/2 x Q 

ACTUAL