Friedrich HEAT PUMPS ユーザーズマニュアル

12

920-087-04

Plastic handles

Plastic 

grommets

1.  Remove the center support and weatherboard if still in stalled 

in the sleeve.

2.  Insert six plastic grommets into the grille openings from the 

outside of the grille as shown in Figure 9.

3.  Insert two #8 x 3/8" sheet metal screws (provided) in the top 

two outside edge plastic grommets, and tighten them half way 
into the grommets.

4.  CAUTION:  Bodily injury can be caused by grilles falling from 

a building during installation. It is rec om mend ed that a safety 
line be attached to the grille and an anchor point inside the 
building during installation.

Installation Instructions Model PXGA Standard Grille

5.  Grasp the grille by the attached plastic handles.  Po si tion 

it with the con den sate drain knock outs facing down.  From 
in side the build ing, ma neu ver the grille through the wall 
sleeve and pull to ward you until the screw heads are 
inserted into the key hole slots at the top of the wall sleeve. 
Tight en the two screws com plete ly.

6.  Insert the remaining screws into the remaining holes and 

tighten securely.

Wall sleeve

Weatherboard

Center support

Stamped Aluminum Grille
Plastic Grommets
#8 x 

3

/

8

" Sheet Metal Screws

1
6
6

Standard Grille

Figure 9