Friedrich 920-087-09 ユーザーズマニュアル

9

FRP010

NOTE: Construct wall opening to comply with all applicable building codes.

MAIN STUDS

JACK STUDS

LINTEL

MOUNTING
SCREW HOLES

NO HOLES IN BOTTOM OF WALL
SLEEVE UNLESS DRAIN KIT IS USED

MAIN STUDS

JACK STUDS

5.  Drill two 3/16" holes through each side of the sleeve approximately 

4" from top and 4" from bottom of sleeve.  Screw four #10 x 1" 

screws (included) or appropriate fasteners for your installation, 

through the holes in the sides of the wall sleeve.

6.  Apply sealant around the wall sleeve where it projects through the 

inside and outside wall surfaces.  Apply the sealant to the screw 

heads or the tops of the fasteners used in Step #5.

7.  If the chassis and exterior grille are to be installed later, leave the 

weatherboard and center support in place, otherwise remove and 

dispose of them.  (See Figure 13, Page 12).

8.  Provide a support lintel if the wall sleeve is installed in a concrete 

or masonry wall (See Figure 10, Page 9).

If the wall is thicker than 13 1/4” a deep wall sleeve or wall sleeve extension 

MUST be used.  The deep wall sleeve may be special ordered through 

your Sales Representative.