Friedrich 920-087-09 ユーザーズマニュアル

Wall Sleeve Installation Instructions (PDXWS)

NOTE:

Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve, chassis and accessories. If the sleeve

projects more than 8" into the room, a subbase or other means of support MUST be used. Please read these instructions completely before

attempting installation.

For Deep Wall Installation (Greater than 13 1/4")

See Page 9

The following instructions apply ONLY to walls less than 13 ¼" in depth.

1. The PXDR10 Drain Kit (optional for new construction) see page 10

if applicable, must be installed before the wall sleeve is installed

into the wall.

2. The External Drain (for new construction or unit replacement) see

page 11, if applicable, must be installed before the wall sleeve is

installed into the wall.

3. From inside the building, position the wall sleeve in the opening and

push it into the wall until it protrudes at least ¼” on the outside. Do

not allow sleeve to be pulled. (See Figure 11, Page 10).

4. Position the wall sleeve with a slight tilt towards the outside to

facilitate condensate drainage. It should be level side-to-side and

the front should be ¼ bubble higher than the back.

Figure 3

Typical Wall Sleeve Installation

NOTICE

DO NOT allow any pitch toward the inside.
Flashing on all 4 sides of the opening is recommended.
Potential property damage can occur if instructions are

not followed.

WARNING

Falling Object Hazard

Not following Installation Instructions for

mounting your air conditioner can result

in property damage, injury, or death.

FRP008

MAX.

16-¼

42-¼

MIN.

LINTEL TO SUPPORT
MASONRY WALLS

ELECTRICAL
RECEPTACLE

WALL OPENING

WALL SLEEVE

INSULATION

SMOOTH SIDE OF SCREW
CLIP FACING INTO ROOM

MAX.

13-¾

NOTE: All 230/208V units are manufactured with a

” power cord and all 265V units with a ” power cord.