Regency C33-NG3 ユーザーズマニュアル

18

Regency

®

 CLASSIC C33-3 Freestanding Gas Stove

Incorrect fl ame pattern will have small, prob-
ably yellow fl ames, not coming into proper 
contact with the rear burner or thermopile 
or thermocouple.  

Conduct an inspection of the venting system 
at least annually. Recommended areas to 
inspect are:

1)  Check areas of the Venting System which 

are exposed to the elements for corrosion. 
These will appear as rust spots or streaks, 
and in extreme cases, holes. These com-
ponents should be replaced immediately.

2)  Remove the Cap, and shine a fl ashlight 

down the Vent. Remove any birds nests, 
or other foreign material.

3)  Check for evidence of excessive condensa-

tion, such as water droplets forming in the 
liner, and subsequently dripping out the 
joints, Continuous condensation can cause 
corrosion of caps, pipe, and fi ttings. It may 
be caused by having excessive lateral runs, 
too many elbows, or exterior portions of the 
system being exposed to cold weather.

4)  Inspect joints, to verify that no pipe sections 

or fi ttings have been disturbed, and conse-
quently loosened. Also check mechanical 
supports such as Wall Straps for rigidity.

1)  Loosen the thermocouple or thermopile with 

a 7/16" wrench at bracket.

2)  Disconnect thermocouple by loosening nut 

from the valve with a 9mm wrench. Discon-
nect thermopile by loosening 2 screws 
marked TP on the valve.

3)  Drop the thermocouple or thermopile down 

from the bracket and pull it out of the unit.

4)  Reinstall the new ones in reverse order.

The aeration adjustment rod is attached to the 
air shutter on the burner. The air shutter adjust-
ment rod is located under the ashlip on the right 
side. The rod is used to adjust the aeration on 
the burner. This adjustment is performed by the 
installer and is primarily used in installations at 
high elevations. Push the rod in for a yellow 
fl ame, or pull out on the rod for a bluer fl ame. 

Air shutter opening:
 Natural 

Gas 

7/16"

 Propane 

Wide 

open