Regency F38-LPG2 ユーザーズマニュアル
Regency F38-2 Freestanding Gas Heater
9
INSTALLATION
AERATION
ADJUSTMENT
The burner aeration is factory set but may need
adjusting due to either the local gas supply or
altitude.
adjusting due to either the local gas supply or
altitude.
F38-2 with 38 mj
F38-NG2
NG: Full open
F38-LPG2
LPG: 6.4 mm open
Caution: Carbon will be produced if the air
shutter is closed too much.
shutter is closed too much.
Note: Any damage due to carboning re-
sulting from improperly setting the
aeration controls is NOT covered
under warranty.
aeration controls is NOT covered
under warranty.
Embers.
Embers
The "02" refer numbers (i.e. 02-65) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
with care - do not force into position.
2) Sprinkle the embers on the left and right
sides of the fi rebox base.
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit contains the following:
a) 02-65 Rear
Log
b) 02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left
c) 02-44 Front Left Log
d) 02-46 Left
Top
Log
e) 02-45 Front Right Log
f) 02-47 Center
f) 02-47 Center
Log
g) 02-48 Middle Right Log
h) Embers
h) Embers
902-151
i) Lava
902-154
Note: Install Optional Brick Panels prior to
installing logs.
C)02-44
Pins on Rear Log Support
A)02-65
B)02-56
3) Place Rear Log A)02-65 on the two pins on
the rear log support.
4) Place the Middle Left Log B)02-56 on the
two pins as shown.
5) Place Front Left Log C)02-44 onto the 2
front pins as shown.