Procom QN300RYLA-W ユーザーズマニュアル

A.  This  appliance  has  a  pilot  which

must  be  lighted by control system,
When lighting  the  pilot, follow
t h e s e   i n s t r u c t i o n s     e x a c t l y .

B. BEFORE LIGHTING smell all

around  the  appliance  area  for
gas. Be sure to smell next  to the
floor  because  some  gas  is
heavier  than  air  and  will  settle
on  the  floor.

SEE WARNING in Page 1 for proper
instructiors.

             

   If  you  do not

follow  these  instructions  exactly, a
fire  or  explosion  may  result  causing
property  damage, personal injury or
loss  of  life.

    

  During initial  opera-

tion  of  new  

fireplace

,  burning logs

will  give  off  a  paper-burning smell.
Orange  flame  will  also  be present.
Open  a  window  to  vent  smell. This
will  only  last  a  few hours.

         

  Do not  try  to adjust

heating  levels  by  using  the
equipment  shutoff  valve.

1.    STOP! Read  the safety information,
        page  2.
2.  Make sure  equipment  shutoff

valve  is  fully  open.

C.   Use only your hand to  push  in
control  knob. Never use tools. If  the
the appli ance could not operate , don't
try  to repair it, Call a qualified service
technician or gas supplier.Forced or  at-
tempted  re-pair may result   in  a fire or
explosion.
D.    Do  not  use  this  appliance  if  any
part   has   been   under  water. Imme-
diately  call  a  qualified  service  techni-
cian  to inspect   the appliance  and  to
replace any part of  the  control system
and  any gas  control   which  has   been
under  water.
  

1. Press the IGN/OFF button of
transmitter.
2.Set  the Switch on OFF location.(See
Figure12-2)
  

 1.press the BURNER to set flame OFF
select

If you didn’t receive or mis-place your
remote transimitter,you can press the
emergency button by a pitch rod to
operate remote automatically 

 or 

(see fig 12-2)

Figure  12-2   On/Off Switch