Frigidaire DGGF3032KB オーナーマニュアル

9

In the event of an electrical power outage, the surface 

burners  can  be  lit  manually.  To  light  a  surface  burner, 

hold a lit match to the burner head, then slowly turn the 

surface control knob to LITE. After burner lights turn the 

knob to desired setting. Use caution when lighting surface 

burners manually.

Never extend the flame beyond the outer edge of the 

utensil. A higher flame simply wastes heat and energy, 

and increases the risk of being burned by the gas 

flame.

1.  Place cooking utensil on surface burner.

2.  Push the surface control knob down and turn 

counterclockwise out of the OFF position.

For most cooking - start on the highest control 

setting and then turn to a lower one to complete the 

process. Use the recommendations below as a guide 

for determining proper flame size for various types 

of cooking. The size and type of utensil used and the 

amount of food being cooked will influence the setting 

needed.

wrappings on top of the range when it is in use. 

These items could melt or ignite. Pot holders, towels 

or wood spoons could catch fire if placed too close to a 

flame.

time without cookware on the grate. The finish on the 

grate may chip without cookware to absorb the heat.

High Flame

Start most foods; bring water to a boil; 

pan broiling.

Medium Flame Maintain a slow boil; thicken sauces, 

gravies; steaming.

Low Flame

Keep foods cooking; poach; stewing.



vary when using other types of pans. The color 

of the flame is the key to proper burner adjustment. A 

good flame is clear, blue and hardly visible in a well-

lighted room. Each cone of flame should be steady and 

sharp. Clean burner if flame is yellow-orange.

3.  Release the knob and rotate to the lite position. 

Note: All five electronic surface ignitors will spark 

at the same time. However, only the burner you are 

turning on will ignite.

4.  Visually check that the burner has a flame.

5.  Turn the control knob counterclockwise to the 

desired flame size. The control knobs do not have to 

be set at a particular setting. Use the knob indicator 

settings to adjust the flame as needed. do not cook 

with the surface control knob in the LITE position. 

(The electronic ignitor will continue to spark if the 

knob is left in the LITE position.)